Countermarche Loom Tie Up

When you tie a countermarche loom, all the ties have to be level. All the cords have to be equal length for each harness. Using Texsolv cord makes this an easier task because you can count the number of loops in the cord and also make small adjustments by moving the pegs up or down one loop. I also use a small carpenters level to check that the harnesses are level.

The other type (Type B) has 1 lever in the center and a set of pulleys. The 2 sets of lamms are different lengths - 1 short (I), the other longer (J).

Start at the top of the loom.

There should be a stabilizing pin or rod that fits through a set of holes near A. This rod holds the jacks or levers in place while you set up your loom. It will need to be removed once your loom has been warped. If the rod is missing, a knitting needle works well instead.

The other end of the lever (the outer edge) C is tied to the end of the bottom Lamm - D. The other end of the bottom lamm is attached to the loom through a rod that runs on the side of the loom.
C - D

The bottom shaft of the harness (E) is attached at the center, to the centre hole of the Top Lamm - F.
E - F

When you are weaving, the loom should operate quietly. If you hear the sound of banging wood, check if the lamms are hitting each other when you change sheds. ( I - J) If so, then you will need to increase the distance between I & J slightly. Do this by shortening the tie-up between E & F. This raises the Top Lamm (I) a bit. You will also need to adjust the length of the tie-up between the Top Lamm and Pedals (lengthen (I - K) to compensate for the adjustment.

The pattern tie-up is the same for both types of countermarche looms. (I, J, K)

More about Looms